What are stock kitchen cabinetry? Stock kitchen cabinets are cabinetry that are pre-built to a specific size and then resold by a cabinetry dealer. Stock cabinets are typically produced in 2 inch increments. In some basic kitchen layouts such as an L shaped kitchen you can lay cabinets out without much problem. But what do you do when you are fitting cabinets between two walls? Well in this case the cabinet dealer can supply you with filler pieces to take up any large gaps that will eventually occur by using cabinets that are built within 2 inch increments. These cabinet filler pieces can be cut to fit the remaining gap relatively well. The main disadvantage with stock kitchen cabinets is the aforementioned incremental sizing but also the quality. Although as with anything the lower to mid range priced stock cabinets are typically made from thinner materials and have economy hardware such as cabinet door hinges and drawer slides. There are a few advantages with using stock cabinetry the very first one that comes to mind is cost. Since stock cabinets are mass produced they can be quite affordable. Another advantage is speed, in most cases dealers have access to larger warehouses where the cabinets are stored, and you can have your stock cabinet order within a few short weeks or in some cases days.
The biggest issue with traditional, store bought cabinets is that it could take 8-10 weeks before delivery, so it is very important to make your cabinet selection prior to do starting any demolition or remodeling of your kitchen. There are cabinets available on-line, that could be delivered within 2-3 weeks, but it will depend on what style and construction you are looking for. We will talk about the differences in cabinets later on in the article.
5. Now that we have all the lines marked, it is time to start installing your kitchen cabinets. We are going to start with the corner cabinet (here is where your helper's extra set of hands will be needed). Place the corner cabinet onto the temporary support rail and have your helper hold the corner cabinet in place. Drill pilot holes through the sturdy cabinet back or its support rail and into the wall studs. Screw the cabinet into the wall using two screws that are long enough to penetrate the studs by at least 1 1/2 inches. Check the top of the cabinet for level and the front of the cabinet for plumb. If you have to correct the position, just back the screws out a little bit and top shims behind the cabinet at the stud locations. If it is plumb and level, drive the screws all the way in and add several more into each stud to ensure that the cabinet is secured tightly to the wall.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does collegeresearch.us claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.