5. Now that we have all the lines marked, it is time to start installing your kitchen cabinets. We are going to start with the corner cabinet (here is where your helper's extra set of hands will be needed). Place the corner cabinet onto the temporary support rail and have your helper hold the corner cabinet in place. Drill pilot holes through the sturdy cabinet back or its support rail and into the wall studs. Screw the cabinet into the wall using two screws that are long enough to penetrate the studs by at least 1 1/2 inches. Check the top of the cabinet for level and the front of the cabinet for plumb. If you have to correct the position, just back the screws out a little bit and top shims behind the cabinet at the stud locations. If it is plumb and level, drive the screws all the way in and add several more into each stud to ensure that the cabinet is secured tightly to the wall.
9. If your cabinets end up butting against another wall, you may need a filler strip to make up the last few inches. If you have custom cabinets, they should have been built to fill this gap, but if you are using stock or RTA Kitchen Cabinets the filler strip may be needed. If you do need to use a filler strip, leave the last cabinet detached from the other cabinets. Clamp a straightedge to the face of the nearest installed unit, extending far enough for you to put alignment marks on the end wall. Allow a 3/4" offset behind those marks (for the thickness of the filler piece) and fasten a cleat to the wall. Then install and fasten the last cabinet and measure the gap between its face frame and the wall.
6. Now we are going to move onto the cabinets on either side of the corner cabinet. As you install each one, use the clamps to secure each cabinet to the neighboring cabinet and then check it for plumb with your level. On faceframe cabinets, it is a good idea to drill two 1/8 inch pilot holes through the sides of the faceframe and use screws. In this case, with frameless, ready-to-assemble kitchen cabinets we are going to screw through the plywood sides and use shims in between the cabinets to ensure a tight fit and make sure that the cabinet faces are plumb.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does collegeresearch.us claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.