3. Use a stud finder to locate the wall studs. Use a pencil to mark the stud locations at least 6 inches above and below the line for the bottom of the wall cabinets. Draw straight vertical lines between the top and bottom marks to indicate the center of the studs.
If you will go out to purchase cabinets from even a local store then you will find them a bit expensive. Although a lot of variety in kitchen cabinets is available out there in the market but when you will search for the best and modern designs in kitchen cabinets then you will see that these cabinets will get expensive. Therefore, look for cheap online stores to find latest but affordable cabinets. If you will purchase the cabinets in bulk then you will find them affordable. There are places from where you can purchase wholesale cabinets and these cabinets can be obtained at a cheap rate because of being in bulk.
9. If your cabinets end up butting against another wall, you may need a filler strip to make up the last few inches. If you have custom cabinets, they should have been built to fill this gap, but if you are using stock or RTA Kitchen Cabinets the filler strip may be needed. If you do need to use a filler strip, leave the last cabinet detached from the other cabinets. Clamp a straightedge to the face of the nearest installed unit, extending far enough for you to put alignment marks on the end wall. Allow a 3/4" offset behind those marks (for the thickness of the filler piece) and fasten a cleat to the wall. Then install and fasten the last cabinet and measure the gap between its face frame and the wall.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does collegeresearch.us claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.