4. If you decided to go with the piece of 1' x 3' lumber, now is where you will use (if you decided to go with the U-shaped frame, it will come into play after all your lines are laid out). Screw a temporary 1' x 3' support rail to the wall, aligning the top edge of the rail with the line for the bottom edge of the wall cabinets. Attach it by driving 3 or 4 two inch screws through the rail into the wall studs.
7. After all the wall cabinets are in place, install the corner or end base case cabinet. Use shims where needed to level the cabinet and raise it up to the line which indicates the high point of the floor. Be sure it is level from front to back and from side to side, then screw it to the wall studs. If you don't have a diagonal corner cabinet or blind base cabinet in the corner, push the adjoining cabinet into place and clamp the two units together. Add a filler strip if needed to allow the doors and drawers enough clearance to open and close properly. If necessary, tap shims under the cabinet and behind it to adjust for plumb and level.
· Stock kitchen cabinets: These are mass-produced kitchen cabinet models that install easily; however, they can't be modified to your individual taste unless your either stain or repaint them. These cabinets should therefore not be an option for those who wish to change the look of their kitchen cabinets in the future after installing them. The main advantages of considering these cabinets are that they install easily and are cheap and readily available.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does collegeresearch.us claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.