One of the reasons for the popularity of RTA kitchen cabinets is that they are very convenient and at the same time less expensive than costly custom kitchen cabinetry. Another benefit of RTA cabinets is that you can place an order based on any kind of style or configuration you may have chosen for your kitchen cabinets. Of course, the quality varies depending upon the manufacturer as well as the cost. However, the good quality ready to assemble kitchen cabinets are manufactured by using high quality materials and excellent craftsmanship. Another reason for the popularity of ready to assemble cabinets is that they can be assembled quite easily. In many instances, you have home improvement and building contractors provide ready to assemble kitchen cabinets as a part of their product offerings. The cost of this is included in the overall cost of the project.
7. After all the wall cabinets are in place, install the corner or end base case cabinet. Use shims where needed to level the cabinet and raise it up to the line which indicates the high point of the floor. Be sure it is level from front to back and from side to side, then screw it to the wall studs. If you don't have a diagonal corner cabinet or blind base cabinet in the corner, push the adjoining cabinet into place and clamp the two units together. Add a filler strip if needed to allow the doors and drawers enough clearance to open and close properly. If necessary, tap shims under the cabinet and behind it to adjust for plumb and level.
5. Now that we have all the lines marked, it is time to start installing your kitchen cabinets. We are going to start with the corner cabinet (here is where your helper's extra set of hands will be needed). Place the corner cabinet onto the temporary support rail and have your helper hold the corner cabinet in place. Drill pilot holes through the sturdy cabinet back or its support rail and into the wall studs. Screw the cabinet into the wall using two screws that are long enough to penetrate the studs by at least 1 1/2 inches. Check the top of the cabinet for level and the front of the cabinet for plumb. If you have to correct the position, just back the screws out a little bit and top shims behind the cabinet at the stud locations. If it is plumb and level, drive the screws all the way in and add several more into each stud to ensure that the cabinet is secured tightly to the wall.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does collegeresearch.us claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.