As I mentioned above, you have the option of using a piece of 1' x 3' lumber for the installation or building a frame to support the cabinets (I have included a picture of a sample frame below). This can be made out of 2' x 4's and should be tall enough to support the bottom of your wall cabinets. If you plan on installing more than one kitchen, then I would suggest the frame, but a piece of lumber will do just fine if this is a one time event. In either case, you will need another set of hands to help with the installation.
9. If your cabinets end up butting against another wall, you may need a filler strip to make up the last few inches. If you have custom cabinets, they should have been built to fill this gap, but if you are using stock or RTA Kitchen Cabinets the filler strip may be needed. If you do need to use a filler strip, leave the last cabinet detached from the other cabinets. Clamp a straightedge to the face of the nearest installed unit, extending far enough for you to put alignment marks on the end wall. Allow a 3/4" offset behind those marks (for the thickness of the filler piece) and fasten a cleat to the wall. Then install and fasten the last cabinet and measure the gap between its face frame and the wall.
Once you are able to find the best cabinets then you can get them installed in your kitchen. With a few changes in the kitchen, you will find the kitchen at its best. This will make you save money on the project too.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does collegeresearch.us claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.