What are stock kitchen cabinetry? Stock kitchen cabinets are cabinetry that are pre-built to a specific size and then resold by a cabinetry dealer. Stock cabinets are typically produced in 2 inch increments. In some basic kitchen layouts such as an L shaped kitchen you can lay cabinets out without much problem. But what do you do when you are fitting cabinets between two walls? Well in this case the cabinet dealer can supply you with filler pieces to take up any large gaps that will eventually occur by using cabinets that are built within 2 inch increments. These cabinet filler pieces can be cut to fit the remaining gap relatively well. The main disadvantage with stock kitchen cabinets is the aforementioned incremental sizing but also the quality. Although as with anything the lower to mid range priced stock cabinets are typically made from thinner materials and have economy hardware such as cabinet door hinges and drawer slides. There are a few advantages with using stock cabinetry the very first one that comes to mind is cost. Since stock cabinets are mass produced they can be quite affordable. Another advantage is speed, in most cases dealers have access to larger warehouses where the cabinets are stored, and you can have your stock cabinet order within a few short weeks or in some cases days.
Have you been shopping for kitchen cabinetry and been dissatisfied with the selection of the big box stores and import cabinet dealers? Well perhaps you should really take a close look at considering custom built kitchen cabinets as an option for your kitchen remodel project. Here I will discuss some of the advantages and disadvantages of both stock and custom cabinetry.
9. If your cabinets end up butting against another wall, you may need a filler strip to make up the last few inches. If you have custom cabinets, they should have been built to fill this gap, but if you are using stock or RTA Kitchen Cabinets the filler strip may be needed. If you do need to use a filler strip, leave the last cabinet detached from the other cabinets. Clamp a straightedge to the face of the nearest installed unit, extending far enough for you to put alignment marks on the end wall. Allow a 3/4" offset behind those marks (for the thickness of the filler piece) and fasten a cleat to the wall. Then install and fasten the last cabinet and measure the gap between its face frame and the wall.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does collegeresearch.us claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.